Yamaha DGX-500AD - 88-Note Touch-Sensitive Portable Electronic Keyboard Owner's Manual page 107

4
5
t
5 x 16 mm round head screws
V
Put the keyboard on the stand.
Carefully place the keyboard on the side boards.
Slowly move the keyboard so that the holes on the bot-
tom of the keyboard are properly aligned with the holes on
the angle brackets.
• Be careful not to drop the keyboard or to get your fingers
caught between the keyboard and the stand parts.
B
Install the keyboard to the stand.
Fix the keyboard to the angle brackets, using the 5 x 16
t
mm round head screws .
I Post-assembly checklist
Once you've assembled the stand, check the following
points:
• Are there any parts left over?
➔ If so, read the assembly instructions again and correct
any errors you might have made.
• Is the instrument clear of doors and other movable fixtures?
➔ If not, move the instrument to an appropriate location.
• Does the instrument make a rattling noise when you play it
or move it?
➔ If so, properly tighten all screws.
• Also, if the keyboard makes a creaking noise or seems
unsteady when you play it, refer carefully to the assembly
instructions and diagrams and retighten all screws.
107