Chassis Intrusion Header; Front And Rear Chassis Fan Headers; Processor And Auxiliary Rear Chassis Fan Headers - Intel BLKDP965LTCK - Conroe LGA775 1066 800FSB DDR2 Audio Lan SATA ATX 10Pack Motherboard Specification

Table 21. Chassis Intrusion Header
Pin Signal Name
1 Intruder
2 Ground
Table 22. Front and Rear Chassis Fan Headers
Pin Signal Name
1 Control
2 +12 V
3 Tach
Table 23. Processor and Auxiliary Rear
Chassis Fan Headers
Pin Signal Name
1 Ground
2 +12 V
3 FAN_TACH
4 FAN_CONTROL
2.7.2.1 Add-in Card Connectors
The board has the following add-in card connectors:
• PCI Express x16: one connector supporting simultaneous transfer speeds up to
4 GBytes/sec of peak bandwidth per direction and up to 8 GBytes/sec concurrent
bandwidth
• PCI Express x1: three PCI Express x1 connectors. The x1 interface supports
simultaneous transfer speeds up to 250 Mbytes/sec of peak bandwidth per
direction and up to 500 MBytes/sec concurrent bandwidth
• PCI Conventional (rev 2.3 compliant) bus: three PCI Conventional bus add-in card
connectors. The SMBus is routed to PCI Conventional bus connector 2 only. PCI
Conventional bus add-in cards with SMBus support can access sensor data and
other information residing on the board.
Note the following considerations for the PCI Conventional bus connectors:
• All of the PCI Conventional bus connectors are bus master capable.
• SMBus signals are routed to PCI Conventional bus connector 2. This enables PCI
Conventional bus add-in boards with SMBus support to access sensor data on the
board. The specific SMBus signals are as follows:
⎯ The SMBus clock line is connected to pin A40.
⎯ The SMBus data line is connected to pin A41.
Technical Reference
55