2.3.1
Front Panel Audio Header/Jumper Block
This connector has two functions:
•
With jumpers installed, the audio line out and mic in signals are routed to the back
panel audio connectors.
•
With jumpers removed, the connector provides audio line out and mic in signals for
front panel audio headers.
Table 19 describes the two configurations of this header/jumper block.
CAUTION
Do not place jumpers on this block in any configuration other than the one described
in Table 19. Other jumper configurations are not supported and could damage the
Desktop Board.
Table 19. Front Panel Audio Header/Jumper Block
Jumper Setting
5 and 6
9 and 10
No jumpers
installed
INTEGRATOR'S NOTE
When the jumpers are removed and this connector is used for front panel audio, the
back panel audio line out and mic in connectors are disabled.
Configuration
Audio line out and mic in signals are routed to the back panel audio
connectors. The back panel audio connectors are shown in Figure 7 on
page 37.
Table 12 on page 39 lists the names of the signals available on this
connector when no jumpers are installed.
Technical Reference
45