Samsung HT-E6500 User Manual page 34

Settings
K
Wireless (General) - Automatic
After following Steps 1 to 3 in "Configuring Your
Network Connection" on page 32.
1 . Select Start in the Network Settings screen,
and then press the E button.
The product searches for and then displays a
list of the available networks.
Network Settings
Select your wireless router from the list.
iptime23
ELT
JSY
KT_WLAN_C361
Mirhenge_edu
SO070VOIP
2 . Select the desired network, and then press
the E button.
3 . Select Next, and then press the E button
again.
4 . On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter letters
by selecting a letter with an arrow button, and
then pressing E button.
5 . When done, select Next at the right of the
screen. The product verifies the network
connection and then connects to the
network.
| NOTE |
\ You should be able to find the Security Code or Pass
Phrase on one of the set up screens you used to set up
your router or modem.
K
Wireless (General) - Manual
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
After folloiwng Steps 1 to 3 in "Configuring Your
Network Connection" on page 32.
34
|
English
1 . Select Start in the Network Settings screen,
and then press the E button. The product
searches for and then displays a list of the
available networks.
2 . Select the desired network or the Add
Network, and then press the E button.
3 . Select Next, and then press the E button
again.
4 . If you select the Add Network, enter your
wireless router's name to connect.
Enter numbers directly using the number
buttons on your remote control. Enter letters
1/10
by selecting a letter with the ▲▼◄► buttons,
Refresh
and then pressing the E button.
WPS(PBC)
Select Next, and then press the E button
Previous
again. You can select security type, and then
Next
select Next, and then press the E button
Cancel
again.
5 . On the Security screen, enter your network's
Security Code or Pass Phrase.
Enter numbers directly using the number
buttons on your remote control. Enter
letters by selecting a letter with the ▲▼◄►
buttons, and then pressing the E button.
6 . When done, select Next at the right of the
screen, and then press the E button.
7 . The Network Status screen appears.
The product attempts to verify the network
connection and fails.
8 . Select IP Settings on the right of the screen,
and press the E button. The IP Settings
screen appears.
9 . Select the IP Mode field, and then set it to
Manual.
10 . Use the number keypad on your remote to
enter the Network values. Use the ▲▼◄►
buttons on the remote to move from entry
field to entry field.
| NOTE |
\ You can get these values from your Internet provider. You
can also view these values on most Windows computers.
For instructions, see "Getting the Network Settings
Values." on page 33.
11 . When done, highlight OK, and then press E
button. The Network Status screen appears.
The product verifies the network connection
and then connects to the network. When it
is done, highlight OK, and then press E
button.