Troubleshooting; Checking Error Messages - LG WT6001HV Owner's Manual

38

TROUBLESHOOTING

TROUBLESHOOTING

Checking error messages

If the following message appears on the display, check the following and take the appropriate corrective action.
Message
Water in the washer y Drain hose is bent, pinched, or clogged.
drains slowly or not
at all, or the display
shows:
NOT DRAINING
ERROR (OE)
Washer fills with water y Water supply taps are not open fully.
slowly or not at all, or y Water line hoses are kinked, pinched, or
the display shows:
y Water inlet filters are clogged.
NO FILL ERROR (IE)
y Water pressure to tap or house is too low.
Washer will not turn on y Power cord is not properly plugged in.
y House fuse is blown, circuit breaker has
The display shows: The lid is not closed properly.
LID OPEN ERROR
(dE)
The display shows: y Lid lock switch error
LID LOCK ERROR
(dL)
The display shows: y Water level is too high due to a faulty water
OVERFILL ERROR
(FE)
The display shows: y Clutch error
CLUTCH ERROR
(E6)
Possible Causes
bent.
tripped, or power outage has occurred.
valve.
Solutions
y Make sure the drain hose is free of clogs, kinks, etc.,
and is not pinched behind or under the washer.
y Make sure that the water taps are open fully.
Make sure the hoses are not kinked or pinched. Be
careful when moving the washer.
y Clean the inlet filters. See the Care and Cleaning
section.
y Check another faucet in the house to make sure that
household water pressure is adequate.
y Make sure that the plug is plugged securely into a
grounded, 3-prong, 120-VAC, 60-Hz. outlet.
y Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have
it corrected by a qualified electrician.
y Make sure that the lid is closed properly and press the
START/PAUSE button. After starting a cycle, it may
take a few moments before the drum begins to turn or
spin. The washer will not spin unless the lid is locked
(LID LOCK light will turn on).
y If the lid is closed and locked and the open lid error
message is displayed, call for service.
y If you press the START button while the lid is open, dE
error message will be displayed.
y Make sure that the lid is closed properly and press the
START/PAUSE button. The washer will not spin unless
the lid is locked (LID LOCK light will turn on).
y If the lid is closed and the lid lock error message is
displayed, call for service.
y Close the water taps, unplug the washer, and call for
service.
y Unplug the washer, and call for service.