Table 7
SAN Switch Rack Mount Kit hardware (continued)
Item
Description
(8) #10 adapter washers
(2) 1/4-20 hex nuts with captive star lock washer
(2) 1/4-inch flat washers
CAUTION:
For proper air flow, the SFP media side of the SAN Switch must face the rear of
the rack. This mounting allows air to enter from the front of the rack and to exhaust at the rear
of the rack, similar to the other rack-mounted equipment.
To install the switch in a rack:
1.
Check contents of the shipping carton to verify all the required parts and hardware are
available.
2.
Choose a mounting location in the rack for the switch.
3.
Attach the rear mounting brackets to the rear rack uprights by completing one of the steps
listed on page 40 or page 41.
SAN Switch 2/8V, 2/16V, 2/16N and 4/32 installation guide
39