Preparation For Use - Echo CS-370 Operator's Manual

Bolt (A)
Dimple (D)
Kick Guard
Recess (E)
Nut (F)
Brake lever
(Front hand guard)
Brake connector
Clutch cover
Two nuts
CS-370

PREPARATION FOR USE

®
Rear hole (B)
Front hole (C)
Guide bar
SAW CHAIN IS SHARP! ALWAYS WEAR
GLOVES WHEN HANDLING ASSEMBLY,
OTHERWISE SERIOUS PERSONAL INJURY
MAY RESULT.
KICK GUARD
INSTRUCTIONS
Tools Needed: Two 11 mm Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type (Double Guard)
guide bars.
1. Install bolt (A) in rear hole (B) of Kick Guard
and through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
engage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm
wrenches until snug. Make certain Kick Guard
is flush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
NOTE
Move chain brake lever (Front hand guard,
Brake connector) fully rearward to remove or
install the clutch cover to the chain saw.
1. Remove spark plug lead. (See page 20)
2. Remove two clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
8
WARNING
®
TO BAR
®
P/N 2893201 and
®
®
is tight on
®
must
®