Dell PowerEdge 1750 Hardware Installation Manual page 18

To install the cable-management arm on the back of the system, perform the following
steps:
Facing the back of the rack cabinet, locate the latch on the end of the right slide
1
assembly that you secured to the back vertical rail.
Push the tab on the back end of the cable-management arm into the latch on the end
2
of the slide assembly (see Figure 1-8).
Push the tab on the front end of the cable-management arm into a mating latch on
3
the inner segment of the slide assembly (see Figure 1-8).
The latch clicks when locked.
F i g u r e 1 - 8 .
latch on end of slide assembly
latch on inner segment
of slide assembly
1-12
Rack Installation Guide
The latch clicks when locked.
I n s t a l l i n g t h e C a b l e - M a n a g e m e n t A r m
tab on front end
tab on back end
cable-management arm
stop block