Code Setup; Code Operation - Chamberlain LiftMaster TAC1 Installation And Programming Manual

PROGRAMMING

CODE SETUP

The unit's Master Code is for owner/administrator level commands. The User Codes allow users to activate and
latch relays 1 and 2 and to transmit radio commands on channels one and two.
NOTE: The User Code cannot be the same as the Master Code.
ENTER A USER CODE NUMBERS
1. Enter the Master Code:
beep.
2. Enter the Program Code:
3. Enter New User Code:
4. Enter the Relay/Channel for the Code to control:
2
or no button is pressed.
NOTE: If no button is pressed in step 4, both
relays/channels will activate simultaneously, when in
parallel mode.

CODE OPERATION

MASTER CODE OPERATIONS
TRIGGER RELAY 1 (ONLY)
Enter the Master Code:
NOTE: Requires Relay 2 be in Independent Mode.
ENABLE VACATION (LOCK DOWN) MODE
Locks the system from all User Code activity.
1. Enter the Master Code:
2. Enter the Program Code:
DISABLE VACATION (LOCK DOWN) MODE
1. Enter the Master Code:
2. Enter the Program Code:
TRIGGER RELAY 1 AND CHANNEL 1
1. Enter the Master Code:
2. Enter the Program Code:
TRIGGER RELAY 2 AND CHANNEL 2
1. Enter the Master Code:
2. Enter the Program Code:
USER CODE OPERATIONS
TRIGGER PROGRAMMED RELAY/CHANNEL FOR USER CODE
Enter the User Code:
Relay/Channel will activate.
>> CODE SETUP AND CODE OPERATION
? ? ? ?
The unit will
9
The unit will beep.
? ? ? ?
? ? ? ?
5 2
? ? ? ?
5 3
? ? ? ?
1
? ? ? ?
2
? ? ? ?
The appropriate
DELETE USER CODE NUMBERS
1. Enter the Master Code:
beep.
2. Enter the Program Code:
3. Enter User Code to be deleted:
1 or
ENTER A TEMPORARY (1 SHOT) USER CODE NUMBER
The TAC1 holds 1 temporary User Code.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Temporary User Code:
4. Enter the Relay for the Code to control:
button is pressed.
NOTE: If no button is pressed in step 4, both relays will
activate simultaneously. Expires in 24 hours or after
fi rst use.
ENGAGE PARTY MODE (RELAY 1)
Party Mode will latch relay and trigger corresponding
channel.
1. Enter the Master Code:
2. Enter the Program Code:
To disengage party mode: Enter a valid code into the TAC1
keypad or enter "*9" into the local telephone.
ENGAGE PARTY MODE (RELAY 2)
Party Mode will latch relay and trigger corresponding
channel.
1. Enter the Master Code:
2. Enter the Program Code:
To disengage party mode: Enter a valid code into the TAC1
keypad or enter "*5" into the local telephone.
NOTE: Relay 2 must be in Independent Control Mode to
engage Party Mode on relay 2. See page 13.
14
? ? ? ?
The unit will
The unit will beep.
7
? ? ? ?
The unit will beep.
5 1
1 or 2 or no
? ? ? ?
5 4
? ? ? ?
5 6