GE GLD8760NSS - Tall Tub Dishwasher Owner's Manual page 7

ge.com
Ll start
(continued)
lrl
PDW9000 Series
After selecting the cycle and desired enhancements, touch the START/RESET p ad to ready the
dishwasher to begin the cycle. Closethe door to start the cycle or begin the DELAVSTART countdown.
When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If you don't want to change
the settings, simply touch the START/RESET p ad to ready the dishwasher and close the door to begin
the cycle.
Also, ifa power failure occurs NORMALand HEATEDDRYwill automatically be programmed. Hake any
new selections and touch the START/RESET p ad to begin the new cycle.
When the door is opened, the indicator lights will turn off if the START/RESETpad is not selected within
5 minutes. To activate the display, open and close the door or touch any pad.
Clean
PDW8000 Series and GLD8000 Series
The CLEANlight is illuminated when the selected cycle and enhancements are complete. The light will
stay ON until a pad is pressed or the door is opened and then closed.
PDW9000 Series and CDW9000 Series
The CLEANlight is illuminated and a double beep will sound when the selected cycle and enhancements
are complete. You may remove the dishes at any time. The high-efficiency fan will run quietly for 30
minutes to 4 hours (depending on selected cycle) after the CLEANlight is illuminated to continue drying
the dishes.The fan can be turned off by opening the door and pressing any keypad.
ALL MODELS: T o turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off),
press the HEATEDDRYpad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle
beep option has been toggled.
Flashing displag lights.
Status Indicator Lights What It Means
STA RT/RESET
Cycle has been interrupted by pressing the START/RESET p ad, or there
has been a power failure. Light will stop flashing after the dishwasher
automatically drains out the water. The dishwasher will restart if the
interruption was the result of a power failure.
Recommended dishwasher products.
GErecommends the following products for use in its
dishwashers:
Foryour manual detergent dispenser,Cascade®
and ElectrasoF powder, liquid or gel automatic
dishwasher detergents are approved.
Foryour SmartDispense
TM
Detergent Dispenser,use
only the recommended detergents listed on page
10 of this manual.
Jet Dr&l ® or Cascade Crystal Cleare rinse agents
to remove spots and prevent new film buildup on
your dishes,glasses,flatware, cookware and
plastic. Using rinse agent also improves dry
performance.
• Cascade®Plastic Booster
TM
to remove red staining
inside your dishwasher that can come from some
tomato-based foods.
• Cerama Br&lte®StainlessSteelAppliance Cleaner
to clean the exterior stainless steel panel of GEand
Profile
TM
dishwashers (for stainless steel exterior
models only).