Enclosure Bracket Installation; Enclosure Installation - EAW DSA250 & DSA230 Owner's Manual

5 . 5 . 8 E N C LO S U R E B R A C K E T I N S TA L L AT I O N
Insert each supplied Enclosure Bracket into its slot near each end of the
enclosure, verifying the proper orientation of the enclosure. Insert a
supplied 3/8-16 x 2 in Enclosure Bracket Bolt with its lock washer into
each bracket bolt hole in the enclosure. Thread each bolt into the weld
nut on its Enclosure Bracket and hand-tighten.
CAUTION: Make sure the brackets are installed so the enclosure
orientation will be correct when the enclosure is mounted.
5 . 5 . 9 E N C LO S U R E I N S TA L L AT I O N
Lift the enclosure onto the structure-mounted Wall Brackets
DANGER: It is recommended that lifting the enclosure in place be
performed by at least two people to prevent it from falling during its
installation and causing possible equipment damage, injury, or death.
CAUTION: For DSA Clusters with two or more loudspeakers mounted
one over the other, it is recommended to make all cable connections
before lifting the loudspeakers onto the wall brackets. See Sections
5.2 through 5.6. Once the loudspeakers are mounted, access to the
connectors may be difficult.
IMPORTANT: When installing loudspeakers mounted vertically end to
end, install the lower loudspeaker first.
2X 3/8-16 X 2 LG
HEX HEAD SCREWS
& LOCK WASHERS
Figure 5.5.8 Enclosure Bracket Installation
Figure 5.5.9a Enclosure Installation
2X ENCLOSURE
MOUNTING
BRACKET
P/N 0006118
2X WALL
MOUNTING
BRACKET
P/N 0006119
27