Compaq dx1000 - Microtower PC Hardware Reference Manual page 39

Microtower model

Hide thumbs Also See for dx1000 - Microtower PC:

Table of Contents

Slide the drive in through the front of the chassis (1) until the bezel on the drive is evenly aligned

with the computer front bezel and install the two M3 metric retainer screws (2) as shown in the

illustration below.

NOTE:

M3 metric retainer screws for diskette drives or media card readers are black. Refer to

Additional Drives on page 24

Figure 2-25

10.

Connect the appropriate drive cables:

If installing a diskette drive, connect the power and data cables to the rear of the drive and

connect the other end of the data cable to the connector on the system board labeled FDD1.

If installing a media card reader, connect the USB cable from the media card reader to the

USB connector on the system board labeled JUSB2.

NOTE:

board drive connectors.

11.

Replace the front bezel and access panel.

12.

Reconnect the power cord and turn on the computer.

13.

Lock any security devices that were disengaged when the access panel was removed.

ENWW

Extra drive retainer screws are provided on the interior of the front bezel if needed. The

for an illustration of the retainer screws location.

Installing a 3.5-inch Device (Media Card Reader Shown)

Refer to

System Board Drive Connections on page 26

Installing

for an illustration of the system

Installing Additional Drives

Table of Contents