HP D5259A - Pavilion M70 - 17" CRT Display User Manual page 18

Connections Connections Connections Connections
Your monitor has two connecting cables: a Power
Supply Cord, which connects to a wall outlet,
surge protector or other power source, and a
Signal Cable, which connects to the graphics
adapter of your computer. To ensure safety and
correct operation, always follow these four steps
when connecting the monitor:
1 1 1 1
Make sure the monitor and computer are
turned off. (See previous section on safety.)
2 2 2 2
Connect the power cord to the back of the
display.
3 3 3 3
Plug the other end of the cable into a
grounded outlet.
4 4 4 4
Connect the video cable on the monitor to the
15-pin video graphics connector on the rear
panel of the computer, and fasten the screws.
(If you have an HP Pavilion computer, this port is
marked in orange. For other computers, check
your computer manual for the video port
location.)
Note: Note: Note: Note:
Don't force the cable into the connector; line it up
carefully so you don't bend the pins.
Connections Connections
Connections Connections
15 15 15 15