Canon 1236B001 - EOS Digital Rebel XTi Camera SLR Instruction Manual page 8

Connect the Camera and the Computer and then Start EOS Utility
Connecting a Camera other than an EOS-1D Series Camera to Your Computer
Connection procedure for the EOS 5D, EOS 30D, EOS 20D, EOS 10D, EOS DIGITAL
REBEL XTi/400D DIGITAL, EOS DIGITAL REBEL XT/350D DIGITAL, EOS DIGITAL REBEL/
300D DIGITAL, EOS D60 and EOS D30
Before downloading images to your computer or specifying the camera settings, you must
connect the camera to your computer with the interface cable supplied with the camera.
You can connect the camera while your computer is running.
For instructions on connecting EOS-1D series cameras and your computer, refer to the
page.
Plug the dedicated cable into the computer.
1
Plug the cable into the USB port.
Refer to the computer User's Manual for
information on the terminal areas.
Plug the dedicated cable into your camera.
2
Face the < > mark on the plug to the
front of the camera and connect the plug
to the camera's < > terminal.
Set the camera's power switch to <ON>.
3
Communication between the camera and
your computer starts. At first the pop-up
menu on the right appears, and then the
dialog box in step 4 is displayed.
For Windows 2000, a dialog box such as [Found New Hardware] may appear.
Select [Canon EOS Utility] and then click the [OK] button.
4
EOS Utility starts up and the camera is
ready to communicate with your computer.
Proceed to "Downloading Images from
Your Camera" (p.1-6).
For Windows 2000, a [Event on device]
dialog box appears. Select [Canon EOS
Utility] and then click the [OK] button to
next
start up EOS Utility.
The procedure in steps 3 and 4 is only
necessary when connecting the camera
and your computer for the first time. From
the next time you connect to your
computer, EOS Utility will start up when
you set the camera's power switch to
<ON> in step 3.
The above window shows information displayable when EOS 30D or EOS DIGITAL
REBEL XTi/400D DIGITAL is connected. The displayed information varies depending
on the camera model connected.
If [EOS Utility] does not start up even after performing step 4, double-click the [EOS
Utility] icon on your computer's desktop, or click the [Start] button
([Programs] in Windows 2000)
select [All Programs]
[Canon Utilities] [EOS Utility] [EOS Utility].
Cover/Table of
Contents
Introduction
1
Downloading Images
from the Camera
2
Setting the Cameras
other than the EOS-1D
Series Cameras
3
Setting the EOS-1D
Series Cameras
4
Remote Shooting
Troubleshooting
Index
1-3