Computer Setup-Advanced - HP dc5700 - Microtower PC Utility Manual

Table 5 Computer Setup—Power (continued)
Hardware Power
Management
Thermal
Computer Setup—Advanced
NOTE:
configuration.
Table 6 Computer Setup—Advanced (for advanced users)
Option
Power-On Options
10 Computer Setup (F10) Utility
●
USB Wake on Device Insertion (some models)—Allows system to wake from Standby on USB
device insertion.
● Unique Sleep Blink Rates—This feature is designed to give the user a visual indication of the
sleep state the system is in. Each sleep state has a unique blink pattern:
●
S0 = Solid green LED.
● S3 = 3 blinks at 1Hz (50% duty cycle) followed by a pause of 2 seconds (green LED), i.e.,
repeated cycles of 3 blinks and a pause.
●
S4 = 4 blinks at 1Hz (50% duty cycle) followed by a pause of 2 seconds (green LED), i.e.,
repeated cycles of 4 blinks and a pause.
●
S5 = LED is off.
If this feature is disabled, S4 and S5 both have the LED off. S1 (no longer supported) and S3
use 1 blink per second.
SATA power management enables or disables SATA bus and/or device power management.
● Fan idle mode—This bar graph controls the minimum permitted fan speed.
NOTE: This setting only changes the minimum fan speed. The fans are still automatically
controlled.
Support for specific Computer Setup options may vary depending on the hardware
Heading
Allows you to set:
●
POST mode (QuickBoot, FullBoot, or FullBoot every 1–30 days).
● POST messages (enable/disable).
●
F9 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text F9 =
Boot Menu during POST. Disabling this feature prevents the text from being displayed.
However, pressing
Storage > Boot Order for more information.
●
F10 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F10 = Setup during POST. Disabling this feature prevents the text from being displayed.
However, pressing
● F11 prompt (hidden/displayed). Setting this feature to displayed will display the text
F11 = Recovery during POST. Hiding this feature prevents the text from being displayed.
However, pressing
See Factory Recovery Boot Support for more information.
● F12 prompt (enable/disable or hidden/displayed). Enabling this feature will display the text
F12 = Network during POST. Disabling this feature prevents the text from being displayed.
However, pressing
●
Factory Recovery Boot Support (enable/disable). Enabling this feature will cause an additional
prompt, F11 = Recovery, to be displayed during POST on systems with HP Backup and
F9 will still access the Shortcut Boot [Order] Menu screen. See
F10 will still access the Setup screen.
F11 will still attempt to boot to the HP Backup and Recovery partition.
F12 will still force the system to attempt booting from the network.
ENWW