Sony RDP-XA900IP Operating Instructions Manual page 29

• Delete the unit from your Bluetooth device
and perform pairing again (page 18).
AUDIO IN
There is no sound.
• Make sure the audio connecting cable (not
supplied) is connected firmly.
• Make sure the AUDIO IN function is
selected.
• If each terminal is connected to a different
component, and both are playing back, the
unit will output sound from the component
connected to the DIGITAL (OPT)
terminal.
• The DIGITAL (OPT) terminal supports
linear PCM signal only. You may need to
change the sound setting of the connected
component.
The sound is low.
• Confirm the volume of the connected
external component.
• Confirm the volume level on the unit.
VIDEO OUT
Videos are not displayed on "iPod"
screen.
• Remove the iPod, then remove the
composite video cable (not supplied).
Then, set the iPod on the Docking Tray
again.
• Check the video settings of the iPod.
Videos are not displayed on a monitor.
• Remove and reconnect the iPod from/to
the unit that is connected to the monitor.
Remote control
The remote control does not function.
• Replace the battery in the remote control
with a new one if it is weak.
• Make sure that you are pointing the remote
control at the remote sensor on the unit.
• Remove any obstacles in the path of the
remote control and the unit.
• Make sure the remote sensor is not
exposed to strong light such as direct
sunlight or fluorescent lamp light.
• Move closer to the unit when using the
remote control.
25
GB