Samsung T27B750ND User Manual page 140

Other Information
Issues
Network Connection
The wireless network
connection failed.
Software Update over the
network fails.
Others
Purple/green rolling horizontal
bars and buzzing noise from
the product speakers with a
Component cable connection.
The picture won't display in
full screen.
A Mode Not Supported
message appears.
Caption on product menu is
grayed out.
There is a plastic smell from
the product.
The product Signal
Information is unavailable in
the Self Diagnosis menu.
The product is tilted to the
side.
The channel menu is grayed
out (unavailable).
Your settings are lost after
30 minutes or every time the
product is turned off.
You have intermittent loss of
audio or video.
You see small particles when
you look closely at the edge of
the frame of the product.
Solutions and Explanations
Make sure the product is connected to a wireless IP sharer (router).
Run Network Status in Network
If you have latest Software (SW) version, SW upgrade will not proceed.
Remove the left and right audio connections from the Set-Top box. If the buzzing
stops, this indicates that the Set-Top box has a grounding issue. Replace the
Component video cables with an HDMI connection.
HD channels will have black bars on either side of the screen when displaying up
scaled SD (4:3) contents.
Black bars will appear on the top and bottom of the screen when you watch movies
that have aspect ratios different from your product.
Adjust the picture size options on your external device or the product to full screen.
Check the supported resolution of the product, and adjust the external device's output
resolution accordingly. Refer to the resolution settings of this manual.
You cannot select the Caption
product via HDMI or Component.
The external device's Caption
This smell is normal and will dissipate over time.
This function is only available for digital channels the TV receives from an Antenna / RF
/Coax connection.
Remove the base stand from the product and reassemble it.
The Channel menu is only available when you select the product source.
If the product is in the Store Demo
30 minutes. Change the settings from
the Setup procedure. Select
→ Setup.
System
Check the cable connections and reconnect them.
Loss of audio or video can be caused by using overly rigid or thick cables. Make sure
the cables are flexible enough for long term use. If mounting the product to a wall, we
recommend using cables with 90 degree connectors.
This is part of the product's design and is not a defect.
English - 140
menu to confirm the connection.
menu if you have selected a source connected to the
function must also be activated.
mode, it will reset audio and picture settings every
Store Demo mode to
TV in the Source using your remote, and go to
Home Use mode using
→
Menu