Panasonic EH2511A Operating Instructions Manual page 7

Pore cleanser
Hide thumbs Also See for EH2511A:
Table of Contents

Advertisement

Available languages

Available languages

your skin.
1. Remove any make-up from your
face, leaving just bare skin.
Never use the appliance on
skin coated with cleansing
lotion or facial soap.
2. Add water to the Water Tank.
(See Figure 4)
Unplug the Cap and supply tap
water into the Water Tank, then
replace the Cap.
3. Attach the Wide Cup to the Cup
Socket, making sure that it is
facing outward. (See Figure 5)
4. Slide the Mist Switch to the "on"
position, then slide the Power
Switch to the "1" position.
• The Mist Nozzle will produce
a fine spray of water.
• If water drips from the face,
wipe it off with a towel or set
the Mist Switch to the "off"
position.
5. Move the appliance slowly
around the tip of the nose. (As
explained below and shown by
Figure 7.)
• Roughly cleanse the entire
surface of nose without focus-
ing on any particularly spot.
6. Now turn the Power Switch off
and reverse the suction cup so
that the Point Cup is facing out-
ward. Then turn it on again.
(See Figure 6)
7. Move the Point Cup over the
nose in the way described by
the arrows. (As explained below
and shown by Figure 7.)
8. Rinse your face, and apply mois-
turizing lotion or any other skin
conditioner you normally use.
• Keep your face sufficiently
moisturized.
Around the tip and wings of the
nose (See Figure 7)
1. Move the cup all over the nose.
2. Limit use of the Wide Cup over the
whole nose to one minute or less.
3. Limit use of the Point Cup to two
minutes or less.
(Do not repeatedly move over the
wings of nostrils where the skin is
thin.)
Use only the Point Cup if you have
concerns about skin irritation.
Cleaning your pore
cleanser
After using the appliance
(See Figure 8)
• Both the body of the appliance
and the cups can be washed
using water.
1. Put some water (warm if you
like) in a washbowl.
• Do not use hot water
• Do not use detergent
2. Remove the suction cup, soak
the Suction Hole (Filter) in the
water, and turn the Power
Switch on to wash for about 15
seconds.
3. Remove the appliance from the
water. Then, leaving the appli-
ance switched on for about 30
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eh2511

Table of Contents