Director 2/140; Director 2/64 (Rear View) - HP 316095-B21 - StorageWorks Edge Switch 2/24 Planning Manual

1
2
Figure 2: Director 2/64 (rear view)
The director provides a modular design that enables quick removal and
replacement of FRUs. The power module assembly at the rear of the director also
provides a 9-pin, D-type subminiature (DSUB) maintenance port for connection
to a local terminal or remote terminal. Although the port is typically used by
authorized maintenance personnel, operations personnel can use the port to
configure director network addresses.

Director 2/140

The Director 2/140 is a third-generation, enterprise-class switch that provides
switched fabric connectivity for to up to 140 Fibre Channel devices.
illustrates the front of the director.
Each UPM card provides four 2.125 Gbps Fibre Channel port connections
through duplex small form factor pluggable (SFP) fiber-optic transceivers.
Shortwave laser transceivers are available for transferring data over multimode
fiber-optic cable. Longwave laser transceivers are available for transferring data
over single-mode fiber-optic cable. Fiber-optic cables attach to director port
transceivers with duplex LC connectors.
SAN High Availability Planning Guide
Redundant fan modules
Power module assembly with
AC power switch
Introduction to HP Fibre Channel Products
Redundant serial crossbar
3
(SBAR) assemblies
Figure 3
25