Removing A Gpu Adapter From The Bladecenter Gpu Expansion Unit - IBM HS22 - BladeCenter - 7870 Installation And User Manual

14. Connect the cable to the expansion-unit system board. Replace the retention
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 54.

Removing a GPU adapter from the BladeCenter GPU expansion unit

Use this information to remove a GPU adapter from the BladeCenter GPU
expansion unit.
Note:
1. The following illustration shows how to remove a GPU adapter from the
2. The illustrations in this document might differ slightly from your hardware.
To remove a GPU adapter from the BladeCenter GPU expansion unit, complete the
following steps:
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on page
4. If an expansion blade is installed on the expansion blade containing the adapter
5. Remove the expansion-blade riser assembly from the BladeCenter GPU
36
BladeCenter HS22 Type 7870, 1936, and 1911: Installation and User's Guide
A
bracket and tighten the screws (B), as shown in the illustration above.
BladeCenter GPU expansion unit.
page 21.
the blade server from the BladeCenter unit" on page 23 for instructions).
24 for instructions).
you want to remove, remove it (see "Removing an optional expansion unit" on
page 26.)
expansion blade:
a. Disconnect the auxiliary power cable (A) from the GPU adapter, as shown
in the following illustration.
B