Quick Installation - ViewSonic E75 User Manual

Quick Installation

1 Connect video cable
Make sure both the E75 and computer are
powered OFF. Connect the video cable to
the computer, then to the E75.
®
Macintosh users: Connect a Macintosh
adapter (part No. VMAC-1) to the video
cable, then to the E75. To order an adapter,
contact ViewSonic
this guide). You will need to provide your
E75's serial number.
2 Connect power cord
Connect the power cord to a properly
grounded AC outlet, then to the E75.
3 Power-ON computer and monitor
Power-ON the computer, then power- ON
the E75 monitor.
NOTE: At this point Windows
may receive a message asking them to
install the E75's INF file.
4 Install INF and ICM files
For CD-ROM: Insert the CD-ROM into your
system, wait for it to auto-start, select
"Monitor Drivers," and follow the on-screen
instructions.
For diskette: Insert the diskette into your
system, run install.exe, and follow the on-
screen instructions.
AC IN
Wall
Socket
Power cord
6
Getting Started
®
(see the back cover of
®
98 users
Monitor Base
5 Windows users:
Setting the Timing Mode
(
Resolution and Refresh Rate)
Example: 1024x768 @ 75Hz
Resolution Right-click on the Windows
desktop > Properties > Settings >
"Desktop Area." Set the resolution.
Refresh Rate (vertical frequency) See
your graphic card's user guide for
instructions.
®
Use the OnView controls to
6
adjust the screen image.
See Operation , pages 7-10.
Installation is complete!
Enjoy your new E75 Monitor!
To be best prepared for any future
customer service needs:
• Write the serial number (see back of
the monitor) in "For your Records"
on page 1 of this guide.
• Register the warranty of your monitor
on the Internet at:
http://www.viewsonic.com
Back of
Computer
Video Cable
ViewSonic E75