Operation; Cleaning - Dukane Projectors Operation Manual

OPERATION

Place the projector on a firm level surface at a convenient operating
height. Be sure vent areas of unit are not blocked. Plug the power
cord into a 120V, 60 Hz AC outlet. Move power switch to ON position.
Place a transparency on the stage and turn focus knob until image
is in focus. Image elevation is adjusted by moving optical head up
or down.
Models equipped with a lamp changer system allow change of lamp
by sliding a lever.
3
1. Lamp Changer (2000 Lumen Series)
2. High/Low Lamp Switch (3000 or 4000 Lumen Series)
3. Lamp Changer (3000 or 4000 Lumen Series)

CLEANING

For best performance, keep your projector free of dust. Keep covered
when not in use.
Cleaning: Use a soft, lint-free cloth to remove dust from stage
glass and projection lens. Lens cleaner may be used on these
components.
Mirrors: Do not attempt to clean mirrors with cleaning
agents — use a soft lens brush to remove dirt.
Fresnel Lens: Use a soft, lint-free cloth or soft brush to remove
dust. The Fresnel lens may be removed by pressing the two plastic
latches.
TURN OFF POWER
BEFORE CHANGING LAMP!
Primary Lamp
1
Reserve
2
4