Selecting A Source; Adjusting The Picture Size And Position - Dukane 8946 User Manual

Selecting a Source

Selecting the computer or video source
Using the Remote Control
OFF ON
POWER
VIDEO RGB VIEWER
AUTO ADJ. LASER
Press any one of the RGB, VIDEO or
VIEWER buttons.
ASPECT FREEZE 3D REFORM
HELP POINTER PIC-MUTE
VOLUME MAGNIFY SLIDE
ZOOM FOCUS FOLDER
SLIDE
LIST
NOTE: If no input signal is available, the projector will display a blue background
(factory preset).
Selecting from Source List
Press and quickly release the SOURCE button on the projector cabinet
to display the Source list. Each time the SOURCE button is pressed, the
input source will change as follows: "RGB1", "RGB2" (computer or DVD
with component output), "Video" (VCR, document camera, or laser disc
player), S-Video", "DVI (Digital)", "Viewer" (slides on a PC card), or "LAN"
(wired or wireless signal aired from a PC).
To display the selected source, press the ENTER button.
Detecting the Signal Automatically
Press and hold the SOURCE button for a minimum of 1 second, the
projector will search for the next available input source. Each time you
press and hold the SOURCE button, the input source will change as
follows:
RGB1 RGB2 Video S-Video
If no input signal is present, the input will be skipped. When the input
source you wish to project is displayed, release the button.
Press the ENTER button.
Source List
DVI (Digital) Viewer
E-19

Adjusting the Picture Size and Position

Place your projector on a flat level surface and ensure that the projector
is square to the screen.
Lift the front edge of the projector to center the image vertically.
Move the projector left to center the image horizontally on the screen.
* If the projected image does not appear square to the screen then
use the 3D Reform feature for proper adjustment. See page E-20.
Adjust the Tilt Foot
1. Lift the front edge of the projector.
Adjustable Tilt Foot Lever
Adjustable Tilt Foot
2. Push up the Adjustable Tilt Foot Levers on the right and left sides of
the projector to extend the adjustable tilt feet (maximum height).
3. Push down the Adjustable Tilt Foot Levers.
4. Lower the front of the projector to the desired height (max. 44.5mm/
1.8") and release the Adjustable Tilt Foot Lever to lock the Adjustable
tilt foot. There is approximately 10 degrees of up and down adjust-
ment for the front of the projector.
WARNING: To avoid premature lamp failure, do not tilt the front of the
projector up or down by more than 15° from level.
Adjustable Tilt Foot Lever