Table of Contents
Advertisement
Chapter 6
PIX 525
Installing a Circuit Board in the PIX 525
This section includes the following topics:
•
•
•
The PIX 525 Restricted Interface Options can have a maximum of six interfaces, and for the Unrestricted
Note
Interface Options, a maximum of eight interfaces.
Table 6-3
restricted and unrestricted interface options.
Table 6-3
Restricted Interface Options
3 FE
2 FE + 1 VPN Accelerator
3 GE
2 GE + 1 VPN Accelerator
1 GE + 1 FE
1 GE + 1 FE + 1 VPN Accelerator
1 4-Port FE
1 4-Port FE + 1 VPN Accelerator
2 4-port FE
To install a circuit board in the PIX 525, perform the following steps:
Step 1
Locate the grounding strap from the accessory kit. Fasten the grounding strap to your wrist so that it
contacts your bare skin. Attach the other end to bare metal on the PIX 525 chassis.
Step 2
Remove the screws from the rear panel of the component tray and slide the tray out (see
78-15170-02
Fast Ethernet Circuit Board, page 6-17
VPN Accelerator Circuit Board, page 6-18
Gigabit Ethernet Circuit Board, page 6-18
lists the possible options/examples of configuration choices available for the PIX 525
PIX 525 Interface Options
Unrestricted Interface Options
3 FE
2 FE + 1 VPN Accelerator
3 GE
2 GE + 1 VPN Accelerator
1 GE + 2 FE
1 GE + 1 FE + 1 VPN Accelerator
1 4-port FE
1 4-port FE + 2 FE
2 4-port FE
1 4-port FE + 2 GE
1 4-port FE + 1 VPN Accelerator
1 4-port FE + 1 VPN Accelerator + 1 FE
1 4-port FE + 1 VPN Accelerator + 1 GE
Cisco PIX Security Appliance Hardware Installation Guide
Installing a Circuit Board in the PIX 525
Figure
6-14).
6-15
Advertisement
Table of Contents
