Asus I220GC User Manual page 32

2. IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connectors are for Ultra DMA 100/66 signal cables. There
are three connectors on each Ultra DMA 100/66 signal cable: blue, black, and
gray. Connect the blue connector to the motherboard's IDE connector, then
select one of the following modes to configure your device(s).
I220GC
I220GC
Single device Cable-Select or Master -
Two devices
•
•
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
1-20
R
IDE Connector
Drive jumper setting
Cable-Select
Master
Slave
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.
Mode of device(s) Cable connector
Black
Master Black
Slave Gray
Master
Black or gray
Slave
Chapter 1: Product introduction