Section 6- Urc-102 Master Controller - ACR Electronics RCL-50 Product Support Manual

Figure 6- URP-102 Point Pad™
Surface Mount Case with gasket and Flush Mount Case with gasket

SECTION 6- URC-102 Master Controller

Mounting
The Master Controller can be mounted in any position near the searchlight that is
protected from the weather. Check in advance that the coax cable from the Point Pad™
and the wiring harness from the searchlight can be routed to this location. Mount the
Master Controller with the wires and coax facing down. Use an appropriate fastener for
your mounting location. Use a sealant in fastener holes to prevent moisture intrusion.
General wiring scheme
The RCL-50B has a unique wiring scheme. Special attention must be paid to the
following chart. The Master Controller is supplied with an in-line fuse-holder on the
orange power lead. Use only 15 amp fuses in this fuse-holder. See Figure 9 for the
master controller wiring diagram.
WARNING: Failure to follow this arrangement may damage components.
Master Searchlight Power Source Lead Function
Controller Wire Cable Wire
Orange +12 VDC or +24 Power
VDC**
Blue Ground Ground
Yellow Yellow Lamp Power
Green Green Lamp Ground
Red Red Up
White White Down
Black Black Right
Brown Brown Left
Table 1
9
Y1-03-0141D