Wireless Network Installation; Connect The Ethernet Cable - Epson C11CA27201 - WorkForce 40 Color Inkjet Printer Network Installation Manual

Wireless Network Installation

To connect your printer wirelessly, you need to know the name (SSID) of your
wireless network. If your network has security enabled, you also need to know the
WEP key or WPA passphrase. Write down this information below:
■
Network name (SSID): _________________________________________
■
WEP key or WPA passphrase: ____________________________________
This information is stored in your network's router, and may have been entered
when the router was first set up. If you don't have this information, contact the
person who set up your network before you begin. You may also be able to log
onto the router from your computer and check its setup screens. See your router's
instruction manual for details.
Note:
You should also write down whether the WEP key is in ASCII or hexadecimal format. If
the WEP key is 5 or 13 characters, it's ASCII. If it's 10 or 26 characters, it's hexadecimal.
If your router gives you a choice of WEP keys to use, note which one is currently active.
Usually the first WEP key is active, unless you've selected a different one.
If your passphrase contains upper- or lowercase letters, be sure to note them correctly.
The printer supports the following wireless security modes: WEP 64, WEP 128, and
WPA-PSK.

Connect the Ethernet Cable

Note:
This is a temporary connection used to configure the printer. You will be prompted to
remove the cable when configuration is complete.
1. Connect an Ethernet network cable to the port on your printer.
LAN (10/100)
Wireless Network Installation
3