Binatone CAPRICE 500 Manual page 11

T elephone operation continue...
To mute the
mouthpiece or
microphone
1
2
MUTE
Inserting a
Pause in the
dialing
sequence
RD/P
STORE
Storing a
1
Number in a
2
One-Touch
memory
3
Speed
1
dialing
2
During a call, the phone mutes the microphone
or the mouthpiece so that the person on the
other end cannot hear you.
Press MUTE button once.
While the microphone is muted, MUTE
be shown on the lower right corner of the display.
Press MUTE button again to get back to the call.
For some switchboard systems, an access number
must be dialed (usually an 8 or 9) to get another
dial tone and an outside line. Pressing REDIAL/
PAUSE button immediately after the access number,
a pause of about 3.6 secs. will be entered, and the
desired number can be dialed immediately.
Press REDIAL/PAUSE button to insert a pause when
dialing or storing Long Distance Access Codes.
In standby mode, press STORE button.
Enter the telephone number, up to 22 digits.
The memory cannot exceed 22 digits during
programming and if exceeded, the memory will
not store the number.
Press the desired memory location (M1, M2,
or M3) button.
Note: When the Memory buttons are full and
you wish to store a new number in memory,
follow steps 1 to 3. The new number will
replace the old number stored in memory.
Lift the Handset, or press SPEAKERPHONE
button on the Base unit.
Press the One Touch memory location M1,M2,
or M3 button.
The number dials automatically.
11
MUTE will
MUTE MUTE MUTE