Inline Fuel Filter; Oil Tank; Oil Indicator Light - Eton VIPER 50M Owner's Manual

reserve in the tank to allow the unit to be
taken to a refueling location.
When you have to switch to the "RES"
position you must refuel the unit as soon as
possible.
ALWAYS CHECK YOUR Fuel level before
you start riding your
Remember: You can drive further in one hour
on your ATV than you can walk in one day.

Inline Fuel Filter

Your ATV is equipped with an inline fuel filter
to prevent dirt and debris from entering the
carburetor and engine.
Check the filter for dirt or damage before each
ride and at each refueling. Replace the filter if
dirty or damaged.
The filter should be replaced every 600 hours
of operation and at the start of each season.
To replace the filter, first turn the fuel valve to
the "OFF" position. Then carefully compress
the wire clamp rings until the clamp is free of
the fuel line. Slide each clamp away from the
filter about ¾".
Remove the filter from the fuel line by holding
the line and pulling the filter. Install the new
filter by inserting the filter into the fuel line and
returning the clamps to the original position.
Turn the fuel valve to the "ON" position and
check for leaks. Inspect the fuel lines for cuts,
ATV.
abrasions and deterioration. Replace fuel lines
as needed.
DO NOT start or operate the engine if the fuel
filter or lines are leaking. Leaking fuel can cause
a fire.
Engine Oil Tank
2 Cycle Engine
Your ATV uses 2 cycle oil to lubricate the engine.
The oil tank is located under the seat at the front
of the unit. Oil is drawn from this tank by an oil
injector pump when the engine is operating.
Oil Level Warning Light
Page 12