Eton ATV RXL 50 Service Manual page 33

(The picture of right side is for ATV RXL 50M)
Remove engine switch housing on the left handle bar.
Remove rear brake level bracket.
(For all type)
Remove the bolts attaching the upper holder cover.
Remove the handlebar holder and handlebar.
INSTALLATION
Put the handlebar on the lower holders.
Make sure the handlebar punch mark with
the tops of the handlebar lower holders.
Install the handlebar upper holders with
the L or R marks facing forward.
Tighten the forward bolts first, and then tighten
the rear bolts.
Install the handlebar upper holder's cover.
Install the switch housing, aligning the boss
with the hole. Tighten the upper screw first then
tighten the lower one.
32