Mounting The Cutter Guard - Dolmar MS-260 U, MS-330 U, MS-430 U, MS-230 C, MS-260 C, MS-330 C Instruction Manual

Installing the cutter guard
Important: Safety regulations and your own safety make
it imperative to use the right cutter guard with a given
cutting tool!
Tool/guard combinations for the MS-260 U / MS-330 U / MS-430 U
Cutting tool
4-tooth star blade: Part no. 351 511 010
Outside diameter: 30 mm (9"), arbour: 0.0 mm (4/5")
2-line trimmer head Part no. 351 50 030
15 m Part no. 369 4 070
10 m Part no. 369 4 07
Tool/guard combinations for the MS-230 C / MS-260 C / MS-330 C
Cutting tool
2-line trimmer head Part no. 351 50 030
15 m Part no. 369 4 070
10 m Part no. 369 4 07
A
6
7
B
8
10
warning: Use only the cutting tools shown here! It is not
permitted to use other cutting tools as this can increase dan-
ger of accidents and cause damage to the equipment!
Cutter guard
Part no. 351 504 101
Part no. 351 504 101
and
Part no. 351 504 10
Install the guard extension
Cutter guard
Part no. 351 504 101
and
Part no. 351 504 10
Install the guard extension

Mounting the cutter guard

- Hook the hood (a/5) by the cutout (a/1) on the lug (a/2).
- Insert and tighten bolt (a/3) and nut (a/4).
Mounting the guard extension for use with trimmer head.
- See above for installation of the cutter guard.
- Attach the guard extension (B/6) supplied with the brushcut-
ter to the upper part of the cutter guard (a/5), bending it to
fit the contour of the guard.
- Attach the trimmer line knife (B/7) to the guard extension
(B/8) with the bolt (B/6).
note: If the trimmer line has been extended (see "Adjusting
the line") the trimmer line knife automatically cuts the line
ends to the same length during use.