Connecting The Ac Adaptor - Gigabyte M1305 Series User Manual

How To Remove the Battery Pack
To remove the battery simply follow the easy steps below.
Locate the 2 battery clips (Shown as 1 & 2) and clip them in
opposite directions. Clip 1 will stay locked; clip 2 needs to be held
in the open position. Locate the gap (circled) and use it to lift the
battery.
Once lifted, pull the battery out of the bay, (Shown as 3) and
continue until the battery is completely out of the bay. Ensure to
store the units battery in a safe and secure place so that it does not
get damaged.
3
2
1
Booktop M1305 SERIES USER'S MANUAL

1.3 Connecting the AC adaptor

Connect the AC adaptor when you need to charge the battery or
want to operate using direct power. If the notebook is new and has
not been used the battery pack will need to be charged before you
can operate from the battery use battery power.
The AC adaptor can be connected to any power source supplying
from 100 to 240 volts and 50 or 60 hertz. This allows the AC Adaptor
to work in most countries and regions.
It is recommended to use only the AC Adaptor supplied with the
M1305 and any AC Adaptor approved by the supplier. Using any
other adaptor could cause damage or malfunction and might result
in injury.
1. Connect the power cord to the AC adaptor.
2. Connect the AC adaptor to the DC-In Jack on the left side of the
notebook.
3. Connect the power cord to the power outlet
2
1
3
3