Gate Operator/Canadian Programming - Dodge 2008 LX49 Magnum Owner's Manual

144 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
7. Return to the vehicle and press the programmed
HomeLink button twice (holding the button for 2 sec-
onds each time). If the device is plugged in and activates,
programming is complete.
If the device does not activate, press the button a third
time (for 2 seconds) to complete the training.
If you are have any problems, or require assistance,
please call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink
repeat each step for each remaining button. DO NOT
erase the channels.

Gate Operator/Canadian Programming

Canadian radio-frequency laws require transmitter sig-
nals to "time-out" (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to "time-out" in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace "Programming
HomeLink" Step 3 with the following:
3. Continue to press and hold the HomeLink button
buttons, while you press and release - every two seconds
("cycle") your hand-held transmitter until HomeLink
has successfully accepted the frequency signal. The
EVIC display will change from "CHANNEL # TRAIN-
ING" to "CHANNEL # TRAINED."
If you unplugged the device for training, plug it back in
at this time.