Advertisement
A Message for the Client
The model you have selected is shipped in 2 separate boxes to protect certain
FILTER
components. The filter comes in one box, and the outer shell of the unit,
containing the motor and the fan, comes in another. Filters must be installed
ASSEMBLY
before turning the unit on in order for it to work. AllerAir technicians
recommend removing the base, installing the filter, and replacing the base
D, DS and DX
according to the following steps:
Step 1
Step 2
Make sure the unit is set to "Off,"
Using a #2 Philips screwdriver,
and unplug it. Lay the unit upside
remove the four screws that hold
down, so that the wheels face up.
the base onto the unit.
Step 4
Step 5
Reach inside the unit, and remove
Gently insert the carbon filter
only 1 of the 2 felt pads.
(either a Model D, DS or DX
Carbon) into the unit, either end
Step 7
Step 8
Replace the base, making sure the
Replace the four screws.
arrow on the gold sticker lines up
with unit's rear seam.
6
AllerAir Industries Inc.
Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com
Step 3
Grasp the wheels. Remove the base
by pulling gently on the wheels.
NEW
CARBON
Step 6
Put back the felt pad removed in
STEP 4.
Step 9
Turn the unit back onto its wheels.
It is now ready for use.
REPLACING HEPA
CARBON FILTERS
AND/OR
STEP 1
STEP 2
Make sure the unit is set to
Using a #2 Philips screwdriver,
"off" and the unit is unplugged.
remove the four screws that
Place the unit upside down,
hold the base onto the unit.
so that the wheels face up.
STEP 4
STEP 5
Reach inside the unit, and
First, remove the carbon filter.
remove felt pad.
(pull up gently by placing thumbs
on the inner side of the filter)
NEW
HEPA
STEP 7
STEP 8
Now, place the new HEPA
Then, place the new
filter into the unit.
carbon filter into the unit.
See page 5 for instructions on
replacing carbon filling.
Step 10
Replace the base, making sure the
Step 11
arrow on the gold sticker lines up
with unit's rear seam.
Replace the four screws.
AllerAir Industries Inc.
Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com
STEP 3
Grasp the wheels. Remove
the base by pulling gently
on the wheels
STEP 6
Then, remove the HEPA filter
with the same technique.
NEW
CARBON
Step 9
Put back the felt pad
removed in STEP 4.
Step 12
Turn the unit back onto its
wheels. It is now ready for use.
3
Advertisement
