Dodge 2006 Freightliner Owner's Manual page 205

WARNING!
In order to avoid loosing a wheel and in order to re-
duce the risk of fatal or serious injuries or vehicle
damage, please follow these safety instructions:
• Always replace wheel bolts that are damaged or
rusted.
• Never apply oil or grease to wheel bolts.
• If a wheel hub thread is damaged, you must not
drive the vehicle. Consult a qualified specialist
workshop.
• Only use genuine wheel bolts approved from the
vehicle manufacturer and specified for your
vehicle's rims. Check tightness of wheel bolts or
nuts regularly and retighten with a torque wrench,
if necessary. Tighten wheel bolts or nuts in a cross-
pattern sequence. After changing a wheel, the
wheel bolts or nuts must be tightened once the
vehicle has been driven for about 30 miles (50 km).
If new or repainted wheels are fitted, the wheel
bolts or nuts must be retightened again after about
600 to 3000 miles (about 1000 to 5000 km).
Rotation pattern for single and dual rear wheels
Single Rear Wheels:
• Rotate the tires by axle. Never change the direction
of rotation of your tires. Make sure that on one axle
just one type of tire (same size, type construction,
load and speed rating) is used.
Dual Rear Wheels:
• Rotate front tires by axle and the outer rear tire side
to side if there is no approved direction of rotation.
The tires used on dual wheel assemblies should be
STARTING AND OPERATING 205
5