Advertisement
S E T
U P
• Take the humidifier out
of its carton. Remove the
water tank from the right
side (Figure 1). Remove
the power unit from the
left side. Then remove any
additional packing materi-
al and the hardware pack-
et containing the four
swivel casters.
Fig. 1
• To install the swivel cast-
ers (optional), turn the base
upside down and align the
casters with the four holes
at the bottom of the base.
Push the casters into the
holes until a distinct "click"
is heard (Figure 2).
NEVER USE A TOOL
TO STRIKE THE CASTERS
INTO THE BASE–
THIS COULD RESULT
IN DAMAGE TO THE
BASE, CAUSING
WATER LEAKAGE.
• Return the base to its
original upright position.
Fig. 2
• Select a firm, level,
flat location — at least six
inches (15 cm) from any
wall for proper air flow
and convenient to an
electrical outlet.
• Place the humidifier on
a water-resistant surface,
as water can damage
furniture and some floor-
ing. Duracraft will not
accept responsibility for
property damage caused
by water spillage.
F I L L
I N G
We recommend that the
humidifier be disinfected
prior to first use. Please
see CLEANING instructions.
• To reduce residue
buildup, remove the
Natural Moisture
before filling the humid-
ifier. Run them under
cold water. Turn the filters
upside down before repo-
sitioning them in the reser-
voir base.
To help extend the life of
your filters, repeat this
step every time you fill
your humidifier.
• Remove the power unit
from the left side of the unit.
• Remove the No Drip™
water tank from the right
side of the unit.
• Turn the No Drip™
water tank upside down
and remove the fill cap by
turning counter-clockwise.
If the water tank will not fit
under a faucet for direct
filling, use the Fill Hose.
Fit the funnel end of the
hose over the faucet and
place the small end into
the water tank (Figure 3).
Fig. 3
®
filters
Advertisement
