Sony PCWA-A100 - Wireless Lan Access Point Getting Started page 7

Register a new Access Point.
1.
Select the new Access Point.
2.
Delete the old Access Point.
3.
(2)If multiple Access Points are registered and you have another Access Point available for wireless communications,
Select another Access Point.
4.
Delete the old Access Point.
5.
Register a new Access Point.
6.
Select the new Access Point.
7.
(The Encryption Key of the computer on which you used one of the Access Point Setup Utilities is automatically changed.
There is no need to re-register the Access Point.)
Peer to Peer
Check this option to build a wireless LAN environment without the Access Point where direct communications among
computers are enabled.
Note
Make sure to check Peer to Peer only on the first computer you register the Access Point using the Wireless Palette.
Channel
This option becomes available for selection when Peer to Peer is checked. When other wireless LANs exist in close proximity,
specify a unique channel for each LAN to avoid radio interference.
Click OK.
5.
A new Access Point is registered. To use the new Access Point, you must
To change the registration data of the Access Point
Delete the registered Access Point, then register a new one.
select it as the Access Point to use.
Page 7