Neutral Adjustment - Dixon ZTR Safety And Operating Manual

CARE AND MAINTENANCE

NEUTRAL ADJUSTMENT

1. Lift seat.
2. Block up the unit so that the drive wheels are off the
ground.
3. Loosen ball joint jam nuts on control rod.
Note: The front jam nuts are left hand threads.
4. With steering control arms in the "out" neutral
position, start the engine and run at fast idle.
5. Adjust the neutral position by turning the control rod
until the wheels do not rotate.
6. Re-tighten the jam nuts on the control rod and
check to see that the drive wheels are not turning.
7. Repeat steps 3-6 for the other side.
8. Shut off engine before removing the blocks.
42