Table of Contents
Advertisement
Available languages
Available languages
2.2 Replace bars by new bars
1
6
2 3
4
–
Screw the sound absorber 7 in the upper drill-hole. Screw the
screw connections GD-E 5 and 6 in the other two drill-holes.
Tighten the screw connections 5 and 6 so that the threads are
correctly sealed by the applied sealing compound.
–
Remove the nuts of the old bars at pedal 1 and drive 4. Remove
the old bars.
–
Fit the new bars 3 instead of the old bars. Put on the washers and
screw on the nuts 1 and 4 again.
–
Loosen screw 2 in order to adjust the position of the pedal. Adjust
the pedal to fit and tighten the screw 2 again.
5
6
7
Advertisement
Chapters
Table of Contents
