Brush Roll; Brush Roll Belt - White 4870GZ - Eureka "The Boss" SmartVac Vacuum Owner's Manual

HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag,
belt, and brush roll often.

Brush Roll

The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.

Brush Roll Belt

The brush roll belt turns the brush roll to agitate, sweep, and comb the carpet nap. Check the belt regularly to be sure it is
in good condition. Replace the belt if it cracks or tears. Cut away any hair or threads wound around the brush roll or the belt
pulley because the buildup could cause the belt to rotate unevenly.
How To Replace Brush Roll Belt,
NOTE: Turn off the switch and unplug the electrical cord
before replacing belt. Belt pulleys can become
hot during normal use. To prevent injury, avoid
touching the motor shaft when checking the belt.
1. Move brush roll control lever to hard floor position.
Motor
Shaft
Brush
Roll
Pulley
3. Remove brush roll. Place new belt around motor shaft
and brush roll.
NOTE: The new belt will appear to be too large. This is
normal.
12
3
Part No. 61110
1
2. Remove 3 base plate screws using a Phillips ®
screwdriver. Lift base plate off base.
4. Insert left end into base.
2
4