Dell PowerEdge 2400 Installation Manual page 5

     
7. Slide the power supply out of the system chassis.
8. Install the PSDB onto the PSDB tray (see Figure 1-3):
a. While holding the PSDB by its edges, position the PSDB so that the three
tabs on the PSDB tray fit through the corresponding slots in the PSDB and
the two power supply connectors face the back of the chassis.
b. Slide the PSDB toward the back of the system about 1 cm (a quarter of an
inch).
c. Secure the PSDB by tightening the thumbscrew.
Dell PowerEdge 2400 Systems — Installing Redundant Power Supplies
Power
supply
Power-supply
mounting
screws (2)
1-3