Advertisement
Quick Links
INSTRUCTION MANUAL
AUTO-PUMP
AIR COMPRESSOR SYSTEM
INPUT :120 volt, 60 Hz, 4.2 AMPS
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
120VAC
MODEL #091-9B-1
OUTPUT: 100 PSI MAXIMUM
1 YEAR WARRANTY
TOLL FREE: 800-346-0857
BOOK# 091-9B-1
Rev A: 12-14-04
file: 091-9b-1-reva
®
FAX: 631-567-5826
.
Advertisement
Related Manuals for KUSSMAUL Auto-Pump 091-9B-1
Summary of Contents for KUSSMAUL Auto-Pump 091-9B-1
- Page 1 120VAC AIR COMPRESSOR SYSTEM MODEL #091-9B-1 INPUT :120 volt, 60 Hz, 4.2 AMPS OUTPUT: 100 PSI MAXIMUM 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826...
- Page 2 INTRODUCTION The 091-9B-1 Auto-Pump Air Compressor system is a 120 volt 60 Hz shaded pole A.C. motor operating a single cylinder air compressor designed specifically for installation on vehicles with air brakes . During long idle periods of the vehicle when even the slightest seepage can cause an air brake system pressure to drop below the brake lockup pressure, the Auto Pump automatically starts to maintain the pressure.
- Page 3 CAUTION NO CONDENSATE OR WATER MUST BE ALLOWED TO ENTER OR ACCUMULATE IN THE OUTPUT OF THE AUTO PUMP. ROUTE OUTPUT PRESSURE LINE DOWNWARD FROM AUTO PUMP TO PERMIT MOISTURE TO DRAIN AWAY. WATER IN THE PUMP OUTLET WILL INDUCE FAILURE ! WATER DAMAGE WILL VOID WARRANTY...
- Page 4 VEHICLE TUBING INSTALLATION 1. Mount all components in a suitable location, preferably in a high area above the air system . Do not mount in engine compartment or near any source of heat or dirt . The system may be connected to any point in the vehicle's air system .
- Page 5 VEHICLE WIRING INSTALLATION 1. The Auto Pump is supplied with a 120 volt A.C. line cord and is ready to operate. The line cord may be plugged into an available outlet or the cord may be cut and permanently wired to the 120 volt A.C.
- Page 6 SPECIFICATION & OUTLINE AUTO PUMP Input : 120 volts A.C. 60 Hz, 4.2 amps Weight: 13 lbs Motor Horsepower: 1/8 HP Motor Type: Shaded pole A.C. Compressor Output: 0.76 CFM Open Flow, 100 PSI Maximum. Pressure Switch: Adjustable Set Point-Factory set to 70 PSI Cut-in, 90 PSI Cut-out Switch Differential: 20 PSI Nominal Outlet Connection: 1/4 NPT, Female...
- Page 7 TEMPLATE AUTO PUMP 3.50 7/32 DIA. HOLES 4PLACES 4.75...
- Page 8 SPARE PARTS LAYOUT AUTO PUMP...
- Page 9 Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others.