Download Print this page

KUSSMAUL 091-9 AUTO-PUMP Instruction Manual

12vdc air compressor system

Advertisement

Quick Links

BOOK# 091-9-3
INSTRUCTION MANUAL
®
AUTO-PUMP
12VDC
AIR COMPRESSOR SYSTEM
MODEL #091-9
NOTE :
The 091-9 Auto-Pump consists of
a 12volt motor driven compressor
INPUT :12 volt, 12 amp
OUTPUT :100 PSI MAXIMUM
1 YEAR WARRANTY
.
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
TOLL FREE: 800-346-0857
FAX: 631-567-5826

Advertisement

loading

Summary of Contents for KUSSMAUL 091-9 AUTO-PUMP

  • Page 1 ® AUTO-PUMP 12VDC AIR COMPRESSOR SYSTEM MODEL #091-9 NOTE : The 091-9 Auto-Pump consists of a 12volt motor driven compressor INPUT :12 volt, 12 amp OUTPUT :100 PSI MAXIMUM 1 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796...
  • Page 2 INTRODUCTION The Auto-Pump Air Compressor system is a compact electric motor operated single cylinder air compressor designed specifically for installation on vehicles with air brakes . During long idle periods of the vehicle when even the slightest seepage can cause an air brake system pressure to drop below the brake lockup pressure, the Auto Pump automatically starts to maintain the pressure.
  • Page 3 CAUTION NO CONDENSATE OR WATER MUST BE ALLOWED TO ENTER OR ACCUMULATE INTHE OUTPUT OF THE AUTO PUMP. ROUTE OUTPUT PRESSURE LINE DOWNWARD FROM AUTO PUMP TO PERMIT MOISTURE TO DRAIN AWAY. WATER IN THE PUMP OUTLET WILL INDUCE FAILURE ! WATER DAMAGE WILL VOID WARRANTY...
  • Page 4 VEHICLE TUBING INSTALLATION 1. Mount all components in a suitable location, preferably in a high area above the air system . Do not mount in engine compartment or near any source of heat or dirt . The system may be connected to any point in the vehicle's air system .
  • Page 5 . To lower cut-in turn range nut counterclockwise . Do not exceed 100 PSI . 5. 091-9 AUTO PUMP can be wired to a positive or negative system vehicle . 6. Optional switch and fuse can be installed as shown (use 20 amp rated switch and 15 amp SLO- BLO fuse).
  • Page 6 TEMPLATE AUTO PUMP 5 3/16" 3/16" DIA. HOLE 3 PLACES 1 3/4" 3 1/2"...
  • Page 7 SPECIFICATION & OUTLINE AUTO PUMP Input : 12 volts D.C. @ 12 Amperes Weight: 6 lbs Motor Horsepower: .10 HP Motor Type: Permanent Magnet Compressor Output: .30 SCFM @ 80 PSI .35 SCFM @ 60 PSI Pressure Switch: Adjustable Set Point-Factory set to 75 PSI - Cut in Switch Differential: 18 PSI Nominal Outlet Connection: 1/4 NPT, Female...
  • Page 8 Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others.