Troubleshooting - DirecTV MDTV6 User Manual

TROUBLESHOOTING

PROBLEM:
SOLUTION: Replace the batteries with two (2) new AA
PROBLEM:
SOLUTION: Make sure you are aiming the DIRECTV®
PROBLEM:
SOLUTION: Try all listed codes for the device brand being set
PROBLEM:
SOLUTION: Use the VCR codes for your brand. Some combo
PROBLEM:
SOLUTION: Follow instructions in Changing Volume Lock
PROBLEM:
SOLUTION: Due to RCA design (1983-1987), only the original
PROBLEM:
SOLUTION: If original remote control required pressing
PROBLEM:
SOLUTION: Try the "Search Method" again after clearing out
PROBLEM:
SOLUTION: For power on, these products require program-
Mode key does not blink when you press a key.
alkaline batteries (see page 8).
Mode key blinks when you press a key, but home
entertainment device does not respond.
Universal Remote Control at your home
entertainment device and that you are within
15 feet of the device you are trying to control.
The DIRECTV Universal Remote Control does
not control home entertainment devices or
commands are not performing properly.
up. Make sure all home entertainement devices
can be operated with an infrared remote control.
TV/VCR combo does not respond properly.
units may require both a TV code and a VCR
code for full operation (see page 12).
No volume on a second TV.
(see page 27).
L
Channel , Channel
do not work for your RCA TV.
remote control will operate these functions.
Changing channels does not work properly.
ENTER to change channels, press ENTER on the
remote control after entering a channel number.
Tried "Search Method" and still could not find a
working code.
the device key as follows: Press and hold Setup
until mode key blinks twice, then release. Next
enter 9 - 9 - 2. Then press and release the device
key to be cleared two times.
Remote control does not turn on Sony or Sharp
TV/VCR Combo.
ming TV codes on the remote control. For Sony,
use TV code 0000 and VCR code 0032. For Sharp,
use TV code 0093 and VCR code 0048.
M
, and Previous CH
29