Directed Electronics Python G4203P Owner's Manual page 8

➢ Battery Replacement
1.
driver, insert into slot located on
the side of the unit as shown and
carefully pry the front of the unit
up, working your way around the
edge until the front is complete-
ly separated from the housing.
Note:
tomer contact located inside the unit
as shown does not fall out during the
replacement process.
2.
move batteries from clip and replace.
Note:
Verify that the battery polarity is correct when replac-
ing. Batteries are stacked in series and polarity is indicated.
3. Reposition all parts and snap together.
8
Elastomer
Using a small slotted screw-
contact
Front
Make sure that the small elas-
Front
Turn the circuit board over, re-
Elastomer
contact
Front
Elastomer
contact
Elastomer
contact
© 2008 Directed Electronics. All rights reserved.
Front
Front
Elastomer
contact
Elastomer
contact
Circuit Board
Circuit Board
+ +
+
+
+ +