Unpacking And Setting Up Your Soloist; Battery Installation - Directed Electronics Soloist Desktop Docking Station Owner's Manual

UNPACKING AND SETTING UP YOUR SOLOIST

Battery Installation:

Soloist Internal Battery
The battery inside Soloist is used to keep the clock run-
ning in the event of a power loss. It should be replaced
every 2 years. The battery holder is located in the bottom
panel of Soloist dock. It has a slot on one side. Press
in from the side near the slot with your thumb nail to
release the battery cover. Once cover is removed battery
can be installed or replaced. To reinstall battery cover,
insert tabs on opposite side of cover into slots and snap
in place. The battery is a CR2025.
Inserting the Batteries
1. Open the battery compartment cover.
2. Insert the new battery. Make sure that the positive
and negative terminals of the battery are oriented as
shown in diagram.
3. Close the cover.
Remote Control Battery
The instructions for opening the battery compartment
are located on the back of the remote. The battery is a
CR2032.

Precautions
1. Properly dispose of used battery.
2. Do not misuse battery by shorting the positive "+" and
negative "-" terminals or put it into fire. Overheating
may cause the battery to explode and cause a fire
hazard.
3. To avoid accidents, prevent children from playing with
the battery.
Partial bottom view of Soloist
Battery cover
Battery
+
© Directed Electronics, all rights reserved.