Unpacking; Connecting; Startup - BELINEA 2225 S1W Manual

UNPACkING

Carefully lift the monitor out of the packaging and make
sure that all components are included (see fig. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
To set up the device, you must fit the monitor base
together.

CONNECTING

 To connect the monitor to your PC ........................
1. Make sure that the PC and monitor are unplugged.
. Connect the 15-pin signal cable to the monitor and
the PC (see fig. 2).
������� ��������
Figure 2. Connecting the monitor to the PC
 Headphone connector .............................................
you can directly connect your headphone to the monitor
through the monitor's jack (


STARTUP

1. First start your PC and then turn on your Belinea
monitor using the power switch (
status indicator ( in fig. 4) should light up green.

Signal cable
�����
in fig. 4).
in fig. 4). The

Figure 1. Monitor LCD
 To connect the monitor to the power source ........
Connect the separate power cable (
monitor and a grounded outlet.
 Connecting the audio cable ...................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (
end to the Line-Out connector of the computer.
������� ��������
2
1
Figure 3. Connecting the monitor to the power source
. Adjust the image to meet your requirements (see the
following sections "Basic Setup" and "Image settings
using the OSD menu").
. If there is no image displayed on the monitor, consult
the section "Troubleshooting".
Belinea 2225 S1W
ENGLISH
Power cord
Audio cable
VGA cable
in fig. 3) to the

 in fig. 3) and the other
�����
-
Operating Instructions -