Cardo Systems SCALA RIDER FM User Manual page 9

your headset for three seconds to turn on the radio. The radio tunes
in to the last radio station you were listening to. With some phones
you should wait a few seconds after ending a call before turning on
the Radio.
Turning the FM Radio Off
While the radio is turned on, press and hold the Radio Button for
three seconds to turn the Radio off.
Switching Preset FM Radio Station
There are six pre-set Radio stations available on your scala rider FM.
While the Radio is on, tap the Radio Button to cycle between saved
stations.
Searching for a New FM Radio Station
While the Radio is on, press and hold the Volume Up or Volume
Down Button for three seconds or until you hear the next station on
your headset.
Pressing Volume Up will search upwards (higher frequency). Pressing
Volume Down will search downwards (lower frequency). Once a
station is found, searching stops and you can hear the station.
To save this station, refer to the following section.
To continue searching, press the Volume Up or Volume Down Button
again for three seconds.
You may still continue to listen to the current unsaved station.
Pressing the Radio Button in this case will switch to the next saved
station.
Saving an FM Radio Station
The FM Radio is equipped with a memory capacity of six stations.
• Select the station you wish to replace by tapping the Radio
Button until you find the station you want to replace.
• Search for a new station as described above.
• Tap the Radio Button within 20 seconds of finding the station to
save the current station.
If you don't save the station, the Radio will exit search mode without
saving the current station. You can still continue to listen to the
current unsaved station. Tapping the Radio Button in this case will
move to the next saved station.
USING THE MP3 PLAYER WITH YOUR
HEADSET
Your scala rider FM headset can be connected to an MP3
player device by plugging it to the Helmet Clamp's jack with
the MP3 cable.
In order to secure the MP3 cable tightly into place, please proceed as
follows:
1. Use the enclosed Allen Wrench to remove both Allen screws from
Helmet clamp and release the clamp's back plate.
2. Place the MP3 cable holder on the helmet clamp. Both pins on the
MP3 cable holder should be fixed into corresponding indentations
on clamp.
3. Place the Back Plate on top of the MP3 cable holder and secure
all parts together using the Allen screws that were previously
removed, as shown in photo.
4. Attach the clamp and headset onto
your helmet as described previously
in section "ATTACHING THE CLAMP
ON THE HELMET".
5. Attach the speakers to your helmet as
described in section "POSITIONING
THE SPEAKERS".
MP3 cable holder hook
scala rider FM 9
® ™