Installation - D-Link DVG-3104MS - VoiceCenter PSTN Gateway User Manual

Section  - Installation
This section will walk you through the installation process. To connect the DVG-3104MS Gateway, follow these steps:
1. Plug the power adapter into an AC outlet or power strip and plug the other end into the AC input on the back of
the gateway. The Power LED will light up to indicate proper connection.
2. Connect one end of the Ethernet cable to the LAN Port on the back of the gateway and connect the other end of
the cable to your Local Area Network via switch or hub. The LAN LED will light up to indicate proper connection.
3. Connect the phone cable to an available PSTN (FXO) Port on the back of the gateway and connect the other end
to a phone jack.
Note: Avoid disabling your existing phone service while setting up VoiceCenter
use it to set up and test VoiceCenter.
When you have connected all the lines to the DVG-3104MS Gateway, it should look like the diagram below.
D-Link DVG-3104MS User Manual

Installation

. If you have an alternative jack available,
™