Dhcp Server Configuration; Tftp Server Configuration; Cli: Switch Configuration - NETGEAR GSM5212P Software Setup Manual

DHCP Server Configuration

The following information is configured on the DHCP or BOOTP server:
• The IP address (yiaddr) and subnet mask (option1)
• The name of the configuration file (bootfile or option 67)
• The IP address of the TFTP server (option 150)

TFTP Server Configuration

The configuration file is on the TFTP server (for example, switch.cfg).

CLI: Switch Configuration

1. Have the configuration file saved after download from the TFTP server.
(Netgear Switch) #boot autoinstall auto-save
(Netgear Switch) #boot autoinstall start
Autoinstall starts and waits for the boot options from the DHCP server.
(Netgear Switch) #network protocol dhcp
Changing protocol mode will reset ip configuration.
Are you sure you want to continue? (y/n)y
2. Request an IP address, configuration file name, and TFTP IP address from the DHCP
server.
(Netgear Switch) #
Config file 'startup-config' created successfully.
AutoInstalled configuration is saved.
(GSM7224P) #show autoinstall
AutoInstall Mode.............................. Stopped
AutoInstall Persistent Mode................... Enabled
AutoSave Mode................................. Disabled
AutoInstall Retry Count....................... 3
AutoInstall State............................. AutoInstall is
completed.
Autoinstall is now completed.
7000 Series Managed Switch
Auto Install Configuration
26